Tubing Connectorization

TECNO PLAST has developed its own fitting program for the utilization with the tubing quality AE6093. Virtually all fittings are provided as a finished end product. If not otherwise desired, TECNO PLAST performs a 100% pressure hold test with tap water by applying the 1.5-fold operation pressure.

Connections are made under consideration of hygienic aspects in order to minimize residues in the fitting areas.

The material consists of stainless steel 1.4404/1.4435, other materials can be provided upon request. 

Standard surface finish Ra < 0.8 μm, optionally available also as electro-polished finish up to Ra 0.2 μm.

1. AE6093 Tubing Quality (for fitted tubing using the TECNO PLAST Swage-Fitting-System, Reinforcement Layer: PES Yarn)

Remark: Starting at a temperature of 20 °C and while increasing the temperature by 35 °C, the burst pressure must be reduced by 10 %. Above-noted values

correspond to regularly available tubing coils (bulk stocks). For fitted products please consider potential pressure-reducing properties.

2. AE6093 Quality for Non-fitted Tubing

Explanations for a customer-specific TP-Product-Number

Example: ID 10 x 4.0 mm wall thickness

SI tubing, transparent
PES monofilament fiber
transparent cover layer
60 +/- 5 Shore A
ID 10.0 x 2.5 mm
Total wall thickness: 4.0 +/- 0.3 mm
Talcum-free, platinum-cured

Material correspond to:

BfR/FDA/USP Class VI
EP 3.1.9/DIN EN ISO 10993-5
50 m packed in PE bag

Limitations:

Smallest inner diameter: 0.5 mm, minimum wall thickness 1.5 mm
Largest inner diameter*: 55 mm

* The ratio of wall thickness to inner diameter must suitable!

Our Product Number: 10100400903

Configuration see below 1 01 100400 9 03